ITINERY 1. Bottles and cartridge assembly (pre-filled and including 2 small clamps for fitting to printer housing). 2. 10ml Syringe 3. Small needle
Turn on the printer and press the ‘ink’ button. When the printhead has moved to the cartridge removal position unplug the mains cable from the printe
Place the bottles to the left of the printer as shown. NEVER PLACE THE BOTTLES HIGHER THAN THIS (If the bottles are placed higher then the ink may
Plug the printer back into the mains supply and the printhead will move back and forth then perform it’s initial ink charge. Remove the backing tape
After the ink charge print out a nozzle check to see if all the colours are printing correctly. If they are, you are set to go. If not perform a head
Re-filling the bottles Remove the air filter and replace it with the small rubber bung (that you did not throw away). Remove the large rubber bung.
Page 7 Re-priming a system that air has been allowed to infiltrate. If ink is allowed to fall below the recommended minimum levels on the bottles it
Notes EASY FLOW FOUR
Kommentare zu diesen Handbüchern